Sale AJ35PTF-28AR MITSUBISHI AJ35PTF-28AR

"1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.2kw.
Interface: SSCNET III /H.
Power supply: single phase AC100V power supply.
The servo amplifier is limited to 0.4kW.
Special specification: support for CC-LinkIE.Field network motion control.
Servo amplifier supporting IE Field CC-Link network AJ35PTF-28AR.
Ethernet based open network, support for motion control AJ35PTF-28AR
Not only inherited the original product of high performance and high reliability, but also made a further improvement beyond imagination.
MELSERVO-J4 grand debut.
Servo market for the star of tomorrow. World class servo products AJ35PTF-28AR.
The new generation of MELSERVO should be what kind of? The answer to this question is already floating
Out of the water . MELSERVO-J4, it represents the whole digital, the original high performance based on an evolutionary.
Is also fully meet the requirements of human beings and the environment MELSERVO latest masterpiece.
For example, the safety and environmental requirements for the safety of human use and the safety specifications and "to Use Easy" design AJ35PTF-28AR.
To meet the needs of the environmental protection era of energy-saving performance .
Beyond the performance of the evolution of MELSERVO-J4, shocking debut! "Analog channel: 16 channels.
Input / output (resolution): 0 ~ 4000.
Conversion speed: 100ms/16 channel.
Analog module installation.
Power supply: DC24V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timelliness is strong MITSUBISHI AJ35PTF-28AR.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MITSUBISHI AJ35PTF-28AR.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
AJ35PTF-28AR Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ35PTF-28AR&select=5