A0J2-C10 MITSUBISHI A0J2-C10

Used to reduce radio noise.Motor series: low inertia, medium and small capacity.
Using a serial absolute / incremental encoder.
Rated output power: 0.1kw.
Rated speed: 3000rpm.
With the brake: without.
Shaft end: straight shaft.
Comparison of single phase induction motor and servo motor.
The working principle of the AC servo motor is similar to that of the single phase induction motor,
But the rotor resistance of the former is much larger than that of the latter,
So the servo motor is compared with the single machine asynchronous motor,
There are three notable features:
1, large starting torque A0J2-C10
2, a wide range of operation MITSUBISHI A0J2-C10.
3, no rotation phenomenon.
AC servo motor running smoothly, low noise .
But the control characteristic is non-linear, and because the rotor resistance is big, the loss is big, the efficiency is low,
Therefore, compared with the same capacity DC servo motor, the volume is large and the weight is heavy,
So it is only suitable for 0.5-100W small power control system. 2 channel analog output module MITSUBISHI A0J2-C10.
As well as analog input modules, the A1S62DA analog output component is built into a microprocessor,
It can convert binary data into voltage or current signals,
Offset and gain are set and stored in a microprocessor,
It also includes other features as follows:
2 output channels .
High resolution digital input, plus or minus 12000.
Total accuracy plus or minus 1%. Protective film for 12.1 inch screen.
Scrub, 5.
Applicable model: GT15. A 20 pin connector is installed on one side of the loose line.
Length 5M. The length of the line: 5M.
IP level: IP65.
Cable outlet direction: the same side of the motor shaft.
Bending life: standard.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). MELSECNET (II).
Coaxial circuit. Control axis: maximum 32 axes.
Teaching running function: there (when using SV13).
To stop the speed control function at the specified location.
The servo motor can rotate at a predetermined speeed,
After sttarting the specified location to stop the instruction,
Can be set in advance to stop the location A0J2-C10.
You can change the speed by changing the value of the options at the time of the operation,
You can also change the acceleration / decellerration time A0J2-C10.
Phase compensation function.
The mixed function of virtual mode and real mode.
Smooth clutch linear acceleration / deceleration function.
A0J2-C10 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A0J2-C10&select=5