AJ35TB1-16D MITSUBISHI AJ35TB1-16D

Motor series: low inertia, medium capacity.
Rated output power: 45.0kw.
Rated speed: 2000rpm.
With the brake: without.
Voltage: 400V level.
Shaft end: straight shaft.
Brushless motor has small size, light weight, large output, fast response, high speed, small inertia, smooth rotation, and stable torque MITSUBISHI AJ35TB1-16D.
Control is complex, easy to realize intelligent, and its electronic commutation method is flexible, can square wave commutation or sine wave commutation AJ35TB1-16D
Motor maintenance free, high efficiency, low operating temperature, electromagnetic radiation is very small, long life, can be used for a variety of environments.
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
At present, the general use of synchronous motor control, which is a large range of power,
Can do a lot of power MITSUBISHI AJ35TB1-16D.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction.
So it is suitable for the application of low speed and stable operation. MITSUBISHI inverter series: FR-F840 MITSUBISHI AJ35TB1-16D.
Voltage level: three phase 400V.
Power: 22.0kw.
SLD converter rated current: 47A .
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
((rectifier separration type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station AJ35TB1-16D.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme,, used in the control of the external machine AJ35TB1-16D.
No external PID controller is used to control the external machine, so the system cost can be reduced.
AJ35TB1-16D Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ35TB1-16D&select=5