FX1S-20MR-D MITSUBISHI FX1S-20MR-D

The length of the line: 5M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
Bending life: high bending life.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Master station module supporting AnyWireASLINK system MITSUBISHI FX1S-20MR-D.
Connecting sensor and programmable controller.
Free configuration of sensors, control of 512 points of the input and output FX1S-20MR-D
The AnyWireASLINK transmission line (2 lines) can be used for communication to supply power for the sensor, and the sensor can also be conveniently added.
Can through the project software GXWorks2 batch management sensor shedding detection and from the station module settings, etc MITSUBISHI FX1S-20MR-D. ,
Substantial savings in time and cost.Output points: 64 points.
Output form: source type.
Rated output voltage: DC12 ~ 24V.
Max load current: 0.1A/1 point.
Protection function: have.
Common way: 32 point / public end.
Input / output occupied points: 64 points (I/O distribution: output 64 points).
External wiring connection: 40 pin connector two MITSUBISHI FX1S-20MR-D.
The switch input and output module is a device which can collect the input / output of the switch signal,
Digital I/O modules are often called .
The switch signal is collected to the computer or the computer to send the relevant instructions through the RS-485 bus to control the switch of the switch,
Can also be carried out through the RS-485 bus communication,
Remote control switch.
Communication protocol is a standard Modbus protocol or custom protocol. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series.
Rated output: 37kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Special specifications: full closed control 4 wire / support mechanical end encoder ABZ phase input / support positioning mode.
Support position control, speed control, torque control.
Position control to follow the position insstructions .
Wheen the control is inserted, the position control is performed FX1S-20MR-D.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque.
Function of swwitching amplitude FX1S-20MR-D. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth.
FX1S-20MR-D Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX1S-20MR-D&select=5