MITSUBISHI FR-A7AP

Protective film for 10.4 inch screen.
Scrub (frame: white), 5.
Applicable model: GT16. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 7.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC400V.
High precision and high response location control MITSUBISHI .
Full closed loop control can be realized by double feedback control method FR-A7AP
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MITSUBISHI . ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system .
Flexible system configuration.
Can achieve higher load side positioning accuracy!Motor series: low inertia, medium and small capacity.
Using a serial absolute / incremental encoder.
Rated output power: 2 MITSUBISHI . 0kw.
Rated speed: 2000rpm.
With the brake: without .
Shaft end: straight shaft.
Comparison of single phase induction motor and servo motor.
The working principle of the AC servo motor is similar to that of the single phase induction motor,
But the rotor resistance of the former is much larger than that of the latter,
So the servo motor is compared with the single machine asynchronous motor,
There are three notable features:
1, large starting torque.
2, a wide range of operation.
3, no rotation phenomenon.
AC servo motor running smoothly, low noise.
But the control characteristic is non-linear, and because the rotor resistance is big, the loss is big, the efficiency is low,
Therefore, compared with the same capacity DC servo motor, the volume is large and the weight is heavy,
So it is only suitable for 0.5-100W small power control system. MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 500kw.
SLD converter rated current: 1212A.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
To maximize the performance of the motor.
Advanced auto tuning function.
The newly developed PM motor auto tuning feature can be used to operate other manufacturers of PM motors (Yong Ci synchronous motors) in the sensorless state.
Not only can drive MITSUBISHI induction motor and PM motor, but aalso can drive other maanufacturers of induction motor and PM motor MITSUBISHI FR-A7AP.
This means that you can reduce the cost of inventory and supplies.
If the PM motor is produced by a IPM motor or other company using MM-CF, the starting torque is limited to 50%,
EEveen after tuning is not simple to use and positioning control of zero speed torque) induction motor and permanent magnet motor can be combined freely MITSUBISHI FR-A7AP.
FR-A7AP Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-A7AP&select=5