MITSUBISHI MR-J2HBUS1M-A

MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 3.7kw.
SLD converter rated current: 25A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) MITSUBISHI .
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment) MR-J2HBUS1M-A
For applications that require high torque at low speeds, the HD rating is the most suitable MITSUBISHI .
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. For MR-J2S-700A (4) /CP/CL or less.
Encoder adapter for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor MITSUBISHI . Analog channel: 4 channels.
Input / output (resolution): 0 ~ 4000 .
Conversion speed: 100ms/4 channel.
Analog module installation.
Power supply: AC170V ~ 264V.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timeliiness is strong MITSUBISHI MR-J2HBUS1M-A.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MITSUBISHI MR-J2HBUS1M-A.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
MR-J2HBUS1M-A Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J2HBUS1M-A&select=5