MITSUBISHI AJ65SBTB2-16T1 Price AJ65SBTB2-16T1

Power: 55kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor AJ65SBTB2-16T1 Price. (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor AJ65SBTB2-16T1
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Type: MIL connector.
Input form: DC input, negative public end AJ65SBTB2-16T1 Price.
Input points: 16 points.
Rated input voltage / current: DC24V (4mA).
External connection: 1 wire .
IE CC-Link field network module type remote unit.
Select input response time from 0ms/0.2ms/1ms/1.5ms/5ms/10ms/20ms/70ms.
High speed input and output control of single module can be realized by using first order logic function.
IE CC-Link field network remote equipment station. According to the equipment, more easily distributed input and output devices AJ65SBTB2-16T1 Price.
Can be connected to the expansion module, more convenient to expand the input and output points .
Support synchronous communication (using with simple motion control module).
According to the simple motion control module of the network (Master) control cycle of the implementation of the control cycle and its synchronization,
Implementation of multiple simultaneous action from the station. Input type: DC input, positive public end / negative public end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/5mA.
Output form: transistor output, leakage type.
Output points: 16 points.
OFF leakage current: 0.1mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 1 line /1 line type.
40 pin connector type (FCN connector type).
Through the 40 pin connector type (FCN connector type) can be connected to a variety of devices.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timelinness is strong MITSUBISHI AJ65SBTB2-16T1.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MITSUBISHI AJ65SBTB2-16T1.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
AJ65SBTB2-16T1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ65SBTB2-16T1&select=5