MITSUBISHI FX-32E-TB/UL FX-32E-TB/UL

Output points: 16 points.
Output voltage and current: DC24V/AC240V, 2A/1 point, 8A/1 common end.
Output response time: 12ms.
8 point /1 a public side.
Output form: relay output.
40 point terminal station.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered MITSUBISHI FX-32E-TB/UL.
It can avoid the control logic confusion caused by illegal operations FX-32E-TB/UL
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system MITSUBISHI FX-32E-TB/UL.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc . .
MITSUBISHI PLC program simulation debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of the program MITSUBISHI FX-32E-TB/UL.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation. Drive: MR-H_ACN series CC-LINK features.
Rated output: 0.2KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relativelly small volume,

And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive FX-32E-TB/UL.
Usually, such testing system is only used to test the rotational speeedd and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive FX-32E-TB/UL.
FX-32E-TB/UL Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX-32E-TB/UL&select=5