MITSUBISHI MR-PWS2CBL03M-A2-L MR-PWS2CBL03M-A2-L

Cable length: 30m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 MITSUBISHI MR-PWS2CBL03M-A2-L. Function: RS-422 communication (GOT connection).
CPU module connected to the front of the expansion function of the substrate MR-PWS2CBL03M-A2-L
The front of the CPU module can be connected to 1 units at most. Servo motor series: low inertia, small capacity.
Rated output: 0 MITSUBISHI MR-PWS2CBL03M-A2-L. 1kw.
Rated speed: 3000r/min.
Electromagnetic brake: No.
Oil seal: incidental (Note 1, note 2, note 3) .
Power supply: 200V.
Note 1 through HG-KR and HG-MR series 0.1kW and HG-SR series can be supported.
Note 2 with the speed reducer case, do not configure the oil seal.
Note 3 with oil seal HG-KR, HG-MR series servo motor''s appearance size standard is different.
The rated speed is 3000r/min, the maximum speed is 6000r/min MITSUBISHI MR-PWS2CBL03M-A2-L.
The maximum torque of 350% of the rated torque, high torque in the field of high rotation, only to support the HG-KR series products .
Built in absolute position encoder with high resolution.
Standard high resolution absolute position encoder (4194304p/rev (22bit)).
To achieve a higher accuracy of the positioning function.
Improve the environmental performance of HG-KR, HG-MR, HG-RR, HG-UR series of products using IP65. Drive: MR-H_ACN series CC-LINK features.
Rated output: 15KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relativelly small volume,
And thhe measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-PWS2CBL03M-A2-L.
Usually, such testing system is only used to test the rotational speeedd and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-PWS2CBL03M-A2-L.
MR-PWS2CBL03M-A2-L Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-PWS2CBL03M-A2-L&select=5