Sale GT10-C10R4-8PL MITSUBISHI GT10-C10R4-8PL

Motor series: medium inertia, medium power.
Rated output power: 0.5kw.
Rated speed: 2000r/min.
Whether to bring the brakes: with.
Shaft end: Standard (straight).
Protection level: IP65 (IP67).
Features: medium inertia from low speed to high speed three modes for selection, suitable for different applications GT10-C10R4-8PL.
Application examples: transmission machinery, robots, X-Y working platform.
High resolution encoder 131072p/rev (17 bit) GT10-C10R4-8PL
The encoder with high resolution ensures excellent performance and stability at low speed.
All motor dimensions are the same as before and all are compatible with the wiring. Input signal power: 40mA GT10-C10R4-8PL. DC24V
Axis of control: 1.
Output frequency: Max 200kHz.
Weight: 0 . 2kg.
FX3U-1PG is a pulse output module of the maximum output 200kHz pulse train.
7 operation modes needed to take the simple position control.
The speed and the target address can be changed in the positioning operation according to the operation of the project,
Support near S shape plus deceleration. High speed positioning can be carried out smoothly GT10-C10R4-8PL.
Up to 8 units can be connected to FX3U or FX3UC .
Connecting FX3UC requires FX2NC-CNV-IF or FX3UC-IPS-5V. RS-232 to RS422 conversion unit (RS-422 connector: 25-pin).
Applicable models: GT15, GT16. DC input points: 8 points.
Input voltage and current: 7mA, DC24V.
Response time: 10ms.
8 point /1 a public side.
Positive / negative sharing.
Output points: 8 points.
Output voltage and current: DC24V/AC240V, 2A/1 point, 5A/1 common end.
Response time: 12ms.
8 point /1 a public side.
Output form: relay output.
34 point terminal station.
Number of stations: 2 stops.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a haard wired way, and the timelinness is strong MITSUBISHI GT10-C10R4-8PL.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness MITSUBISHI GT10-C10R4-8PL.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
GT10-C10R4-8PL Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=GT10-C10R4-8PL&select=5