A1SD75P3-S3 Positioning control module MITSUBISHI A1SD75P3-S3 Interpolation function: 2 axis linear interpolation, 2 axis arc interpolation 

Enter 64 points.
Above DC7V.
Response time: 16ms.
16 pin connector.
Output 64 points.
Response time: 16ms.
32 pin connector dynamic input and output data.
PLC is introduced by the relay control technology after the development of micro processing technology,
Can be easily and reliably used for switching control MITSUBISHI A1SD75P3-S3.
As the analog quantity can be converted into digital quantity, the number of digital quantity is just a number of switching value,
Therefore, after the conversion of analog, PLC can also be reliable for processing control A1SD75P3-S3
Because the continuous production process often has the analog quantity, the analog quantity control is sometimes called process control.
Analog quantity is not electricity, and PLC can only handle digital quantity, quantity of electricity MITSUBISHI A1SD75P3-S3.
All to realize the conversion between them to have the sensor, the analog quantity into a number of power.
If this power is not standard, but also through the transmitter,
The non-standard power into a standard electrical signal, such as 1-5V, 4-20mA, 0-10V, etc..
At the same time, there is also an analog input unit (A/D),
Transform these standard electrical signals into digital signals,
The analog output unit (D/A), in order to transform the digital quantity after PLC processing into analog quantity -- standard electric signal MITSUBISHI A1SD75P3-S3.
So the standard telecommunication number, the conversion between the number of operations to use a variety of computing MITSUBISHI Positioning control module.
This requires the resolution of the analog unit and the standard electrical signal MITSUBISHI Positioning control module. A1SI61 is designed to control the application of mechanical devices that require high speed response time.
A1SI61 temporarily stop running in order to generate an interrupt signal when the program is running,
And according to the interrupt vector to execute the corresponding interrupt handler MITSUBISHI Positioning control module.
The interrupt start condition can be selected according to the type of the connected device,
That is, the rising edge of the interrupt signal can be selected as a starting signal, and the falling edge of the interrupt signal can be selected as an interrupt.
The popularization and application of PLC programming has been developed rapidly in our country,
It has been widely used in all kinds of mechanical equipment and production process of electrical control devices,
All walks of life have emerged a large number of application of PLC transformation of the results of the equipment.
Understand the working principle of PLC, have the ability to design, debug and maintain the PLC control system,
Has become the basic requirements of modern industry for electrical technicians and engineering students.
The instruction list programming language is a programming language similar to assembly language mnemonic,
As well as assembly language by the operation code and the number of operations.
In the case of the computer for the PLC handheld programmer compile user program.
At the same time, the programming language of the instruction list corresponds to the ladder diagram programming language,
In PLC programming software can be converted to each other. Figure 3 is the instruction sheet corresponding to the ladder diagram of figure 2PLC.
The characteristics of instruction table programming language is used to represent mnemonic operation function,
Easy to remember, easy to grasp;
In the handheld programmer on the keyboard using the mnemonic representation, easy to operate, can be programmed in computer;
There is a one-tto-one correspondence between the ladder diagram and the ladder diagram MITSUBISHI A1SD75P3-S3 A1SD75P3-S3. Its characteristics are basically consistent with the ladder diagram language.