CA5-WPG10-01 Proface CA5-WPG10-01

For 5.7 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.COM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)Adapter for EX module (5 / set)Adapter for EX module (5 / set)Touch panel operation for RGB input modules (Master - from: Mini-B)512MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface CA5-WPG10-01 CA5-WPG10-01 The nut for mounting the display module (10 / set).3.4 Inch Touch Screen anti UV protective film (1 pieces).For 5 Proface CA5-WPG10-01. 7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.GP2500S useFor 3.8 inch models, prevent cable loose from the USB cable fastening clip (5 / set).The main body module and the separate display module are used for connecting the main machine module and the separate display module in the DIN guide rail.A veneer, for the GP4000 series back loading models of full flush (white, 1)7 Proface CA5-WPG10-01. 4 inches, installed to provide the function of dust and moistureSupport CANopen from the station module, with a 12 point digital input, 6 point relay output and 2 point transistor PNP output. Up to 7 EX modules can be connected Proface Waterproof rubber gasket. Protection for GP rear connectors (large and small for each of the 1).USB cable to prevent disconnection of the fastening clip (5 / set)1-0 DVI standard (DVI-D 24 pin convex connector)GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panel5 Proface Waterproof rubber gasket. 7 inches, for the protection of the man-machine interface from oil and chemical pollution (5 / set).COM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface Proface Waaterproof rubber gasket CA5-WPG10-01. The main controller is directly connected to the man-machine interface (D-sub 9 pin concave) for multiple connection (n:1) communication.Standard interface cable for connecting GP and external devices (ssuch as the main controller), with a universal filter Proface CA5-WPG10-01.
Length of 3 meters. For connecting GP operation data with D-Sub RS-232C and power /DIO terminals.