GP2000H-D232-10M Proface RS-232 cable with D-Sub connector Proface GP2000H-D232-10M

Some types of PLC are not connected. Length: 5 meters.A veneer, for the GP4000 series back loading models of full flush (white, 1)Touch screen anti ultraviolet protective film (1 pieces).One end is a loose wire, which is used to carry out RS-232C connection between the host and LT.Clock battery, save system date and time when power is off Proface GP2000H-D232-10M. With a fixed screw of the pre USB protection cover, in compliance with IP66F, IP67F, 1/4X Type only indoor use /13 or ATEX certification (5 / set) GP2000H-D232-10MAdapter for EX module (5 / set)For the DVI input to GP3000Used to display analog RGB (2 channels) on the GP3000Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.10.4 inches (TFT), the GP will be installed to the hard panel to provide dust and moisture proof function Proface GP2000H-D232-10M. 256MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.Digital small keyboard with USB interface.For the direct connection of the MITSUBISHI A series CPU PLC (not to be used at the same time, the programmer) length: 5 meters Proface GP2000H-D232-10M. Portable GP2000H series models accessories, RS-422 single head cable (10 m).COM1 interface with the cable for direct connection to the CPU series PLC ASupport CANopen from the station module, with a 12 point digital input, 6 point relay output and 2 point transistor PNP output Proface RS-232 cable with D-Sub connector. Up to 7 EX modules can be connected.For connecting GP operation data with D-Sub RS-232C and power /DIO terminals Proface RS-232 cable with D-Sub connector. Expansion module for the GP3000 access to the CC-Link network and communication with the CC-Link master station (support for intelligent devices)10.4 inches (TFT), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) Proface RS-232 cable with D-Sub connector. 13 pin input connectors for HTB and 16 pin output connectors. (1 / set)10.4 inches (TFT), for the proteection of the man-machine interface from oil and chemical pollution (5 / set) GP2000H-D232-10M. Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationExtension cable for connecting USB (Mini-B) intterface to front panel Proface GP2000H-D232-10M. For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 5 meters.