HG-JR6014B MITSUBISHI HG-JR6014B High capacity servo motor in low inertia

Servo motor series: medium inertia, small capacity.
Rated output: 0.85kw.
Rated speed: 1000r/min.
Electromagnetic brake: incidental.
Power supply: 200V.
Stable driving of medium capacity and medium inertia type products.
Through the optimization of structural design, to achieve the minimum length of the industry MITSUBISHI HG-JR6014B.
High speed & high torque. Shorten the positioning time, achieve high-speed equipment HG-JR6014B
Reducing the electric torque ripple.
Through the combination of the optimal number of the motor and the slot number, the torque ripple is greatly reduced,
To further realize the smooth constant speed device.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series MITSUBISHI HG-JR6014B.
Rated output: 55.0kw.
SSCNET interface.
Voltage: 3 phase AC400V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller MITSUBISHI HG-JR6014B.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise MITSUBISHI High capacity servo motor in low inertia.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit MITSUBISHI High capacity servo motor in low inertia.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use.The length of the line: 20M.
Relay type.
IP level: IP20 MITSUBISHI High capacity servo motor in low inertia.
Bending life: standard.
Encoder with cable (amplifier side); for HF-KP/HF-MP series. Type: HA-SE series.
Rated output: 0.5KW.
Rated speed: 2000r/min.
Electromagnetic brake: there.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave.
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments.
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction.
So it is suitable for the application of low speed and stable operation.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and thhe target value, the driver is compared,
Adjust the rotor rotation angle MITSUBISHI HG-JR6014B HG-JR6014B.
The accuracy of the servo motor is determined by the accuracy of the encoder.