MR-J3BUS50M-B MITSUBISHI MR-J3BUS50M-B SSCNET III cable (long distance optical fiber, high bending life) 

Fiber length: 3 meters.
SSCNET III cables (standard optical fiber used in control cabinet).
Joints for CN1A and CN1B. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 2.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Special specification: full closed loop control 4 wire / device end encoder ABZ phase input corresponding support function security unit, support positioning mode MITSUBISHI MR-J3BUS50M-B MR-J3BUS50M-B
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
2 low frequency vibration can be suppressed at the same time by supporting the seismic algorithm of 3 inertial equipment MITSUBISHI MR-J3BUS50M-B.
Configurator2 MR to achieve convenient adjustment.
Effectively restrain the low frequency aftershock effect produced by the front end of the boom or the main body of the device 100Hz.
Can effectively shorten the time to control the stability of the aftershock.
In the XY design of trajectory control, improve the accuracy of arc track MITSUBISHI MR-J3BUS50M-B.
At the same time, it can effectively control the phenomenon of quadrant protrusion caused by the rotation direction of the servo motor, which is caused by friction and twisting. Drive: MR-H_ACN series built-in positioning function.
Rated output: 2 MITSUBISHI Cable for electromagnetic brake. 0KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop MITSUBISHI Cable for electromagnetic brake.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimum detectable speed MITSUBISHI CCable for electromagnetic brake MR-J3BUS50M-B.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MITSUBISHI MR-J3BUS50M-B.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.