FR-A740-160K-CHT Manual MITSUBISHI INVERTER FR-A740-160K-CHT BASIC INSTRUCTION MANUAL

Analog output expansion board (1 channel).MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 2.2KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible MITSUBISHI INVERTER INSTRUCTION MANUAL FR-A740-160K-CHT
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI INVERTER INSTRUCTION MANUAL.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Input points: 36 points.
Output points: 24 points.
Power supply voltage: AC240-360V.
Output type: transistor output (drain).
A free combination of PLC.
FX3G basic unit: 14/24/40/60 point.
FX3GA is a compact PLC, simple design and with the basic functions of the FX3 series MITSUBISHI INVERTER INSTRUCTION MANUAL.
Through the strengthening of the built-in function and flexible expansion, expanded in various fields of application.
Third generation standard model FR-A740-160K-CHT INSTRUCTION MANUAL.
High flexibility.
Suitable for small scale control of high cost.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points FR-A740-160K-CHT INSTRUCTION MANUAL.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Memory format: EEPROM.
Number of steps: up to 4000 steps can be used FR-A740-160K-CHT INSTRUCTION MANUAL.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Input signal power: 40mA. DC24V
Axis of control: 1.
Output frequency: Max 200kHz.
Weight: 0.2kg.
FX3U-1PG is a pulse output module of the maximum output 200kHz pulse train.
7 operation modes nneeded to take the simple position control FR-A740-160K-CHT Manual.
The speed and the target address can be changed in the positioning operation according to the operation of the project,
Support near S shape plus deceleration. High sspeed positioning can be carried out smoothly MITSUBISHI INVERTER INSTRUCTION MANUAL.
Up to 8 units can be connected to FX3U or FX3UC.
Connecting FX3UC requires FX2NC-CNV-IF or FX3UC-IPS-5V.