OMRON CJ1W-ID262 Manual CJ1W-ID262 Hardware PROGRAMMING MANUAL

Model: C200H-OD212.
No. of points: 16 pts.
Specifications: 0.3 A, 24 VDC.Unit type: CS1 Special I/O Units.
Product name: Isolated-type,
Resistance Thermocouple Input Units.
points Input: 4 inputs.
Signal range selection:
Set separately for each input.
I/O type: Pt100, JPt100.
Conversion speed (resolution):
100 ms/4 inputs CJ1W-ID262 PROGRAMMING MANUAL.
Externa connection: Removable erminal block CJ1W-ID262
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.15A; 26V, 0.15A.
Standards: UC1, CE.
Provides the functionality of isolators,
power supplies, signal converters,
and other devices.
The Analog Input Unit converts analog,
input signals such as 1 to 5 V or 4 to 20mA,
into digital values, and takes the values,
scaled in industrial units, and transfers,
it to the CPU Unit as the process value CJ1W-ID262 PROGRAMMING MANUAL.
Because of this, no ladder program is required,
at the CPU Unit for scaling.
The Analog Output Unit converts analog output set,
values from the CPU Unit to analog output signals,
such as 4 to 20 mA or 1 to 5 V, and outputs them.
The built-in functions, such as measurement value,
alarms, rate-of-change calculations, and square roots,
have enabled major savings in cost and space compared,
with previous systems CJ1W-ID262 PROGRAMMING MANUAL.
High-resolution Models and 8-point Input Models are,
also available.
By combining the Units, logging/monitoring.
systems can be constructed,
or the Units can be used together with LCBs/LCUs,
to construct complete process control systems.
Parameters can be easily displayed and set in an,
easy-to-understand form without special tools. C500-RM SYSMAC BUS Remote I/O Master Wired C500-RM001-PV1.
APF/PCF.Model : CV500-CN432.
Cable I / O connection.
40M cable length.Power supply voltage: DC100V.
Note: operation with output contacts.
Power supply unit.
The power supply of the CPU rack is supplied by the power supply unit.
The following power units are available for selection.
C200HW-PA204 (voltage: AC100-120V/AC200-240V)
C200HW-PA204S (voltage: AC100-120V/AC200-240V)
C200HW-PA204R (voltage: AC100-120V/AC200-240V)
C200HW-PD024 (voltage: DC24V)
In the past, PC connected to a meeasurement equipment or components must be given to the ASCII unit or BASIC unit to write a communication program CJ1W-ID262 Manual.
Now, PC C200HX/HG/HE is installed on the communication protocol macro function,
Can be configured to these communicaations procedures through the PMCR instruction to the ladder program,
With this function system can be easily connected with a wide range of components CJ1W-ID262 Manual.