FR-A8AX MITSUBISHI FR-A8AX

Protective film for 5.7 inch screen.
Scrub (frame: white), 5.
Applicable model: GT15. Cable length: 15m.
For long distance connections between QCPU and GOT (above 13.2M) (need A9GT-QCNB).
Long distance connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. For 16 point I/O. 0.3 to 1 MITSUBISHI FR-A8AX. 5mm2 (AWG22 to 16).MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0 FR-A8AX4kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table MITSUBISHI FR-A8AX.
AC servo can be used as the driving source of the field network .
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed.32 point connector for compressed flat cable (37 pin D-Sub connector) MITSUBISHI FR-A8AX. Drive: MR-H_ACN series SSC-NET compatible AC servo .
Rated output: 0.1KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. Servo motor series: low inertia, small capacity.
Rated output: 0.4kw.
Rated speed: 3000r/min.
Electromagnetic brake: No.
Oil seal: incidental (Note 1, note 2, note 3).
Power supply: 200V.
Note 1 through HG-KR and HG-MR series 0.1kW and HG-SR series can be supported.
Note 2 with the speed reducer case, do not configure the oil seal.
Note 3 with oil seal HG-KR, HG-MR series servo motor''s appearance size standard is different.
The rated speed is 3000r/min, the maximum speed is 6000r/min.
The maximum torque of 3500% of the raated torque, high torque in the field of high rotation, only to support the HG-KR series products FR-A8AX.
Built in absolute position encoder with high resolution.
Standard high resolution absolute position encoder (4194304p/rev (22bit)).
To achhieeve a higher accuracy of the positioning function FR-A8AX.
Improve the environmental performance of HG-KR, HG-MR, HG-RR, HG-UR series of products using IP65.
FR-A8AX Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-A8AX&select=5