FX2NC-16MR-T-DS MITSUBISHI FX2NC-16MR-T-DS

Purpose: to operate, monitor, and change the parameters through the network.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. Servo motor series: medium inertia, small capacity MITSUBISHI FX2NC-16MR-T-DS.
Rated output: 1.2kw.
Rated speed: 1000r/min.
Electromagnetic brake: No.
Power supply: 200V.
Stable driving of medium capacity and medium inertia type products FX2NC-16MR-T-DS
Through the optimization of structural design, to achieve the minimum length of the industry.
High speed & high torque. Shorten the positioning time, achieve high-speed equipment MITSUBISHI FX2NC-16MR-T-DS.
Reducing the electric torque ripple.
Through the combination of the optimal number of the motor and the slot number, the torque ripple is greatly reduced,
To further realize the smooth constant speed device .
Improve the environmental performance of HG-SR, HG-JR series of products using IP67. Cable length: 3 meters.
For FXCPU (FX0, FX0S, FX0N, FX1S, FX1N, FX2N, FX2NC,) and GOT connection MITSUBISHI FX2NC-16MR-T-DS.
For FXCPU expansion board FX2N-422-B, FX1N-422-BD and GOT connection . 3C-2V/5C-2V coaxial cable.
Single bus.
PC inter network (management station / common station) / remote I/O network (remote control station).
How to choose MITSUBISHI PLC.
MITSUBISHI PLC options include the choice of MITSUBISHI PLC models, capacity, I/O module, power, etc..
MITSUBISHI PLC distribution I/O points and design MITSUBISHI PLC peripheral hardware circuit
Draw the I/O point of the PLC and the input / output device connection diagram or the corresponding table,
This part also can be carried out in second steps.
Design PLC peripheral hardware circuit.
Draw the electrical wiring diagram of the other parts of the system,
Including the main circuit and the control circuit does not enter the PLC, etc..
The electrical schematic diagram of the system composed of I/O PLC connection diagram and PLC peripheral electrical circuit diagram.
So far the system''s hardware electrical circuit has been determined. Motor series: low inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 3.5kw.
Rated speed: 3000rpm.
With a brake band.
Shaft end: straight shaft.
Performance comparison of servo motor and stepping motor.
Stepper motor as an open-loop control system, and modern digital control technology has the essential link.
In the current domestic digital control system, stepping motor is widely used.
With the emergence of digital AC servo system, AC servo motor is morre and more used in digital control system FX2NC-16MR-T-DS.
In order to adapt to the development trend of digital control, most of the motion control system adopts stepping motor or full digital AC servo motor as executive motor.
Although they are similar in contrroll mode (pulse train and directional signal), there are great differences in performance and application FX2NC-16MR-T-DS.
The use performance of the two are compared.
FX2NC-16MR-T-DS Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX2NC-16MR-T-DS&select=5