MITSUBISHI FR-A720-1.5K Price FR-A720-1.5K

Output type: transistor output, source.
Output points: 16 points.
OFF leakage current: 0.30mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module FR-A720-1.5K Price.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in FR-A720-1.5K
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong FR-A720-1.5K Price.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness .
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer FR-A720-1.5K Price. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series .
Rated output: 0.1kw.
Interface type: SSCNET type III fiber communication.
Power specification: single phase AC200V.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed.
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring.
Due to the adoption of the optical fiber communication, the anti noise ability can be greatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable for mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties. Axis of control: 1.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
7 operating modules rrequired for easy positioninng control are provided MITSUBISHI FR-A720-1.5K.
Type of instruction, please refer to the list in front of you.
One can control a shaft.
FX3U, PLC FX2N can connect up to 8 units,
PLC FX2NC can connect up to 4 units,
PLC FX3UC can connect up to 77 uunits, so that it can control more than one independent axis MITSUBISHI FR-A720-1.5K.
Maximum can output 100kHz pulse train.
Positioning control through the control program.
FR-A720-1.5K Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-A720-1.5K&select=5