FR-A720-5.5K MITSUBISHI FR-A720-5.5K

Power: 220kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Input / output type: transistor output (source).
Output points: 8 points MITSUBISHI FR-A720-5.5K.
Input and output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure FR-A720-5.5K
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms.
Using high speed counter automatically adjusted to the minimum value MITSUBISHI FR-A720-5.5K.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis .
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect MITSUBISHI FR-A720-5.5K.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit. Drive: MR-H_ACN series CC-LINK features.
Rated output: 0.6KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relativelly small volume,

And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive FR-A720-5.5K.
Usually, such testing system is only used to test the rotational speeedd and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive FR-A720-5.5K.
FR-A720-5.5K Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-A720-5.5K&select=5