MR-J2-200A MITSUBISHI MR-J2-200A

5.7 inches.
GOT front USB interface with protective cover (for replacement).
Applicable models: GT27, GT25. NTSC/PAL output system.
Applicable model: A985GOT-V. GI fiber optic cable.
Double circuit.
MELSECNET (II) (remote I/O station).
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program MITSUBISHI MR-J2-200A.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system MR-J2-200A
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system MITSUBISHI MR-J2-200A.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc.. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MITSUBISHI MR-J2-200A.
Rated output: 0.6kw.
Interface type: CC-Link communication type (built-in positioning function) .
Power specification: three phase AC400V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and moonitoring and oother operations MR-J2-200A.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

Thhe servo amplifier can be used for speed control operation MR-J2-200A.
When the two stations are occupied, the speed can be set directly by the remote register.
MR-J2-200A Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J2-200A&select=5