PLC L02SCPU-P MELSAP-L Manual MITSUBISHI L02SCPU-P Programming Manual

Output points: 32 points.
Output type: leakage type.
Rated output voltage: DC12 ~ 24V.
Max load current: 0.1A/1 point.
Protection function: have.
Common way: 32 point / public end.
Input / output occupied points: 32 points (I/O distribution: output 32 points).
External wiring connection mode: 40 pin connector L02SCPU-P Manual .
The switch input and output module is a device which can collect the input / output of the switch signal,
Digital I/O modules are often called L02SCPU-P
The switch signal is collected to the computer or the computer to send the relevant instructions through the RS-485 bus to control the switch of the switch,
Can also be carried out through the RS-485 bus communication,
Remote control switch.
Communication protocol is a standard Modbus protocol or custom protocol L02SCPU-P Manual . Cable length: 0.6m.
Weight: 0.19kg.
Definition 1: conductor by one or a plurality of mutually insulated and insulating protective layer made of,
A conductor of electricity or information from one place to another.
Definition 2: usually by a few or several groups (each with at least two wires) cable rope twisted the similar,
Each group of wires are insulated from each other, and are often twisted around a center,
The entire outer bread has a highly insulated cover L02SCPU-P Manual .
The cable has the characteristics of internal power and external insulation. Number of input channels: 2Ch.
Differential drive input.
Maximum count rate: pulse/s 500K MITSUBISHI L02SCPU-P Programming Manual.
Linear counter function.
Ring counter function.
Uniform output function.
Preset function.
Count invalid function MITSUBISHI L02SCPU-P Programming Manual.
Latch counter function.
Sampling counter function.
Periodic pulse counter function.
Flexibly applied to various applications
Combination of functions,
Easy to achieve speed measurement, long measuring function, the single pulse output, the ratio of the set / distribution output, PWM control, cam switch control, such as a wide range of control MITSUBISHI L02SCPU-P Programming Manual.
Single pulse.
To trigger the input as a starting point, with a minimum 25ns unit to adjust the ON/OFF time.
The action time deviation of ON/OFF is ns level, so it can achieve high precision control.

Velocity measurement and length measurement
In addition to the measurement of ON width and OFF width,
Can also achieve different sensor ON time difference and other conditions of the measurement L02SCPU-P MELSAP-L.
The high precision measurement of the smallest 25ns unit can be realized L02SCPU-P Manual .
Delayed output
The output time delay of each channel can be adjusted so that the error output can be realized.