OMRON GRT1-END-M Manual GRT1-END-M OPERATION MANUAL

I/O classification: Analog input.
I/O points: 8.
I/O connections: Molex connector.
Power supply voltage: 24 VDC.
I/O specification: 4 to 20 mA, 0 to 20 mA, 0 to 5 V,
1 to 5 V, 0 to 10 V, -10 to 10 V.
Analog Input/Output Units Compatible with MULTIPLE I/O TERMINAL.
Input block incorporates connectors that can be easily,
mounted or dismounted GRT1-END-M OPERATION MANUAL. (GT1-AD08MX, GT1-DA04MX)
8 or 4 inputs GRT1-END-M
4 outputs.
High resolution of 1/6,000.
High conversion speed of 8 ms/8 points or 4 ms/4 points.
DIN track mounting.
Connector model Terminal Block Model. Name: Multi-channel Power Controller.
Number of control channels: 4.
Heater burnout detection: Not supported.
Load power supply voltage: 400 to 480 VAC GRT1-END-M OPERATION MANUAL.
Optimum Cycle Control for High-precision.
Control with Low Noise.
Smaller than a Normal Power Controller.
Enables low-noise power control in combination with zero-cross.
SSRs. (See note.).
One Controller can control up to 8 SSRs.
RS-485 communications to set manipulated variables and,
heater burnout detection. The Smart FB Library for the G3ZA,
can also be used.
CE Marking.
Main Upgraded Functions GRT1-END-M OPERATION MANUAL.
Soft-start function added for lamp heaters.
Three-phase optimum cycle control added for three-phase heaters.
Combining with special CT for150-A current detection.
Note: The G3ZA must be used in combination with an SSR without the,
zero cross function when the soft-start function is used. Standard certification: No.
Action indicator: No.
Applicable load of output: DC5 2A ~ 110V.
Input rated voltage: DC4 ~ 24V.
Insulation: photo coupler.
Zero trigger function: No.
And the MY type of the same shape of the G3F series of new international standard certification (-VD type).
Achieved UL, CSA, EN (VDE certification) standard certification. (type -VD)
Socket terminal type of same size with MY (2 pole type).
A model with an action indicator to check the status of the input. Type: output module.
Insulation mode: three end two-way photoelectric switch.
Action indicator: there.
Zero trigger function: No.
Applicable load of output: AC100 2A ~ 240V.
Input rated voltage: DC12V.
I/O solid state relay can be used for OMRON I/O type G7TC relay terminal GRT1-END-M Manual.
Input and output composite input module, the output module is complete.
Can be used for I/O type P7TF terminal. Can also be mixed with the I/O type G7T relay.
Can check the workinng status of SSR through the action indicator GRT1-END-M Manual.
Have access to UL, CSA standard certification of the series of products have also been series (-US type)