CA3-ADPSEI-01 Proface CA3-ADPSEI-01

For connecting GP operation data with D-Sub RS-232C and power /DIO terminals.Direct interface Matsushita Electric PLC FP series CPU port.5.7 inches, installed to provide the function of dust and moistureFor multi connection communication, length: 5 meters.For the DVI input to GP300012.1 inches, replace the backlight (1 / set)5 Proface CA3-ADPSEI-01. 7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)One end is a loose wire, which is used to carry out RS-232C connection between the host and LT CA3-ADPSEI-01LT4000M (module type analog), PNP output, DC24V (host).Connect to USB printer (Type-B).12 way 2 digital signals into analog signals and output resultsFor the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 5 meters Proface CA3-ADPSEI-01. Touch screen anti ultraviolet protective film (1 pieces).A veneer, for the GP4000 series back loading models of full flush (white, 1)Memory for extending EX GP-Pro alarm and character table functions.128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface CA3-ADPSEI-01. Disposable supplies used to protect the screen from the pollution of the man-machine interface film (5 sheets / sets)For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters Proface SIEMENS serial adapter. For the man-machine interface hanging in the neck lanyard Proface SIEMENS serial adapter. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connectorThe MITSUBISHI A series PLC is connected to GP, length: 5 m.Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).OMRON SYSMAC series PLC or other main controller) connected to GP, length: 5 m Proface SIEMENS serial adapter. Cable for connecting GP3000 to various modulesAdapter for EX module (5 / set)USB cable fastening clip (Type-A) for preventing disconnection of connection (5 / set) CA3-ADPSEI-01. 10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accesssories Proface CA3-ADPSEI-01. Expansion module for the GP3000 access to the CC-Link network and communication with the CC-Link master station (support for intelligent devices)